1. Pour 3 liters of room temperature water into a clean container. Do not use hot or cold water.
Use measuring jugs (for example 1L + 2L) to get an exact amount.
2. Start stirring the water to create a gentle swirl.
3. Slowly add the powder into the moving water while stirring. Do not pour all at once — add gradually.
4. Continue mixing and make sure the entire packet is fully emptied.
5. Stir well and let the solution sit for 5 minutes.
6. Mix again thoroughly.
Check the bottom — there should be no sediment.
If needed, use a clean hand to check.
7. Let the solution sit for another 10 minutes.
8. Check again — the solution should be evenly mixed with no sediment.
The liquid should look slightly milky / semi-transparent.
9. Measure 100 ml of Dawn dish soap (regular, not Platinum).
10. Slowly add the dish soap while stirring. Rinse the measuring cup with the solution and pour it back in to use all product.
11. Mix thoroughly.

The solution is ready.

• Always use clean tools, clean container, and clean hands
• Wash hands with soap before working
• Always measure precisely (not by eye)
• Water must be room temperature
• Add powder slowly while mixing to avoid sediment
• Make sure there is no sediment at any stage

What affects bubble quality:

Bubble film is very sensitive. The solution may not work properly if:

• There is cream, oil, or lotion on your hands
• There are perfumes, sprays, or strong smells in the air
• There are cooking fumes or grease in the environment
• The room is dusty
• Tools or container are not clean
• Water quality is poor (use bottled water if needed)
• Store prepared solution in the refrigerator between practice sessions to help keep it fresh and prevent spoilage.